Export to Africa Cattle Feed Hammer Mill

Working principle
The hammer mill is fixed with an engine and a power of RP-driven all kinds of different power. 
After the raw materials were put into crushing chamber, the high-speed operated hammer sheets will impact the raw materials over and over again, then the raw materials will be crushed into pre-set size step by step. Then the crushed materials will be leak out from the sieve. The draught fan will convey the leaked materials into separator centrifuge. Finally, the powder material will be discharged down below and the air will be discharged upper.

Technical Parameters of Wood Hammer Mill--- CF420B and CF420C

Model
Power
Voltage V/50Hz
Sieve Screen Size
Sieve Screen Specification
Capacity
CF420C
11kw
380V
680*280mm
2-10mm
200-500kg/h
CF420B
7.5KW
380V
680*280mm
2-10mm
200-500kg/h

Main Features of Wood Hammer Mills
1. With capacity 200-500kg/h, this hammer mill can satisfy a large production demand on a daily basis. 
2. The ability to change screen size, and the option of a variable speed frequency drive control, enable processing a variety of materials using the same hammer mill. 
3. Both coarse and fine grinding can be realized through adjusting the gap between hammers and screen.
4. The core part ---the hammer flake is scientifically designed to have two concussion parts, thus when one part is worn out, you can turn over to use the other part.
5. The angle of the screen can be 180° which allows for high throughput at lower power consumption.
6. Equipped with air blower, the crushed material can be directly collected and transported to next machine for further processing


Hammer mill pictures: